OOAK Table Tennis Forum

New Butterfly Amicus robots
Page 16 of 16

Author:  Dave T [ 05 Nov 2017, 22:44 ]
Post subject:  Re: New Butterfly Amicus robots

Not that I know of. I think I was the one that made it furthest, but never got the project done. I built the controller unit, custom circuit board that fit in a box about twice the size of a pack of cigarettes, and had a prototype control app that ran on the iPhone. A friend did the control app to run on Android, and he presented the app to Butterfly at a trade show. At that point we were losing motivation and wanted Butterfly to take it off our hands. They seemed very interested, but never followed up, and we lost interest in moving forward with the app/controller.

SMGbab - regarding figuring out the motor speeds, what I did was to build a little rpm detector that could count wheel rotations using a light meter reading a stripe I painted on each of the wheels. This worked very well. I also used this to correlate rpms with motor voltages.

Author:  ttnerd [ 16 Aug 2018, 17:07 ]
Post subject:  Re: New Butterfly Amicus robots

I would be very grateful, if there is anybody who can provide infos for me to
control the stepping motors (which hardware fits best to control these 3 motors etc...) or at least infos for getting started.

Dave T, steff76, SMGbab16... are you still reading here? :)

pm or post here would be great!

Author:  ttnerd [ 24 Aug 2018, 15:56 ]
Post subject:  Re: New Butterfly Amicus robots

does anybody know where I can get informations on how to start (hw... etc.)?

Page 16 of 16 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group