OOAK Table Tennis Forum

When you can lift the glass off the rubber without the rubber sticking to it, then it is dry. It might be slightly sticky, so sometimes you might have to peel the glass off, but you should be able to see through the glass if any of the glue is still wet.

Note: It takes long for the glue to dry using the glass method, and depending on the air temperature where you are, it might take 10-20min.

@ speedplay/priior: With the press I try not to tighten it too tight, just enough to keep the rubber and blade in contact all the time while drying. So yes, just using one book to press it should be enough. And 2 bits of wood and 4 screws is all you really need to make a good press, just make sure you have something (like a plastic cover sheet or plastic wrap) covering the rubber surface when you put it into the press so that the wood doesn't do any damage to the rubber surface

_________________
** Never play leapfrog with a Unicorn **

BH: Inspirit Quattro 39deg
FH: Inspirit Quattro 42deg
Blade: Andro Supercore Off- / Gambler Black Diamond Balsa Texalium Off+

Perhaps you should check out this thread on 'super priming":

http://forum.oneofakindtrading.com.au/v ... .php?t=524

_________________
OOAK Table Tennis Shop | Re-Impact Blades | Butterfly Table Tennis bats
Setup1: Re-Impact Smart, Viper OX, Victas VS 401 Setup2: Re-Impact Barath, Dtecs OX, TSP Triple Spin Chop 1.0mm Setup3: Re-Impact Dark Knight, Hellfire OX, 999 Turbo
Recent Articles: Butterfly Tenergy Alternatives | Tenergy Rubbers Compared | Re-Impact User Guide

ok thanks

_________________
DHS Hurricane King
FH: DHS Hurricane 3 Provincial 2.1mm
BH: Nittaku Hammond max.

what would happen if i didnt prime it with the 1-2layer reg glue and only with the 5 layers speed glue?

_________________
DHS Hurricane King
FH: DHS Hurricane 3 Provincial 2.1mm
BH: Nittaku Hammond max.

They say it could detach the topsheet from the sponge in the earlier posts.

_________________
Viscaria. H2 Neo 2.15. Tenergy 05 1.9.