OOAK Table Tennis Forum
https://ooakforum.com/

V300 Parts
https://ooakforum.com/viewtopic.php?f=67&t=36988
Page 1 of 1

Author:  steveh [ 27 May 2020, 22:29 ]
Post subject:  V300 Parts

My Ipong V300 (serial number D..) died yesterday. The motor failed that drives the rotating feed disk. In all fairness, I used the V300 a lot, and I was quite pleased with it. If anyone needs any parts from the V300 except for the feed disk motor, I will be glad to send them for the cost of shipping. I am located in North Carolina in the U.S. I suspect that an older Ipong could easily be converted to the V300 by swapping parts, but I haven't done it, so I can't be sure.

Author:  steveh [ 29 Aug 2020, 22:46 ]
Post subject:  Re: V300 Parts

I (sort of) fixed the v300. I swapped the oscillation motor for the dead feed drive motor. Now the robot is usable again, although obviously without oscillation. I thought other Ipong owners might want to know.

Author:  shiukkh [ 06 Nov 2020, 07:02 ]
Post subject:  Re: V300 Parts

Can anyone sell the iPong V300 Remote control to me ? I lost it, thanks,

Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/