OOAK Table Tennis Forum

Been using OX the past 6-8 months , I try VOC glue and rubber cement. Both doesn’t hold to good, if I would to use a glue sheet would it effect the LP at all? Does it chance the characteristic of the LP? Last how can I take a glue sheet off a blade ? TIA

Been using glue sheets recently,only difference I notice is very slight spin sensitivity which hasn't affected my game,the benefit is worth it imo and I quickly didn't feel this any more
Be careful which glue sheet you choose,some damage the wood fibres when removing,the donic ones are good,also Gewo clean stick has lower adhesion for removal,recommend a light seal of blade

_________________
Tsp Black Balsa 3.0 Tenergy 05 1.9 388d ox black

Thank you for your response, with your experience did it change any reversal or play faster ?

I don't really notice any difference when using a glue sheet either. They are very thin, and in many ways very similar to a layer of glue, so if there is a difference, it's going to be very minor.

_________________
OOAK Table Tennis Shop | Re-Impact Blades | Butterfly Table Tennis bats
Setup1: Re-Impact Smart, Viper OX, Victas VS 401 Setup2: Re-Impact Barath, Dtecs OX, TSP Triple Spin Chop 1.0mm Setup3: Re-Impact Dark Knight, Hellfire OX, 999 Turbo
Recent Articles: Butterfly Tenergy Alternatives | Tenergy Rubbers Compared | Re-Impact User Guide

Would there be a brand that you can recommend?

No noticeable change in speed or reversal and the lp stays stuck down even where the fingers put pressure on it,I think megaspin sells the Donic glue sheets

_________________
Tsp Black Balsa 3.0 Tenergy 05 1.9 388d ox black

Agree, the Donic sheets work great.
Currently also using a Spinlord sheet but it will take long before the rubber will get off my blade, so cannot comment how well they work yet.

_________________
Manipulating spin, hehe...

The Spinlord ones I have stick down really well,need to be really carefull when removing ,these are the previous ones to the xfilm that they sell now,best heating the rubber with a hair dryer to soften the adhesive grip when removing

_________________
Tsp Black Balsa 3.0 Tenergy 05 1.9 388d ox black

If you are tempted to buy the cheap Chinese sheets, better not waste your money as the glue is strong enough to splinter your outer ply even if you have sealed the blade correctly .

I have a nexy glue sheet , it stick to the blade good but it’s not sticking to my OX LP. Is it the glue sheet or the rubber ? Can can I put glue on the rubber then on the glue sheet ? TIA

I think the ones I bought were Xiom, or maybe Andro. I think the European ones are all the same, they have a "strong side" and a "weak side". The strong side sticks to the rubber, the weak side to the blade. That way you can remove the rubber and transfer it to another blade if you have to. The Chinese sheets are to be avoided, since they don't have this feature.

Iskandar